EPM Windows records an application only when two settings allow it: the global recording parameter and an access policy with recording enabled. Configure both to record the sessions of the applications you choose.
Requirements
- Access to the EPM with permission to change parameters and access policies.
- The applications you want to record, so you can add them to an access policy.
Steps
Step 1: Enable the global recording parameter
The global parameter makes session recording available. It does not record anything by itself.
- On Segura® Platform, in the navigation bar, hover over the Products menu and select EPM.
- In the side menu, select Management > Settings > Parameters.
- In the General Settings section, set Enable recording session? to Yes.
- Click Save.
Step 2: Enable recording in an access policy
- In the navigation bar, hover over the Products menu and select EPM > Policies > Windows > Access policies.
- Open the access policy that contains the applications you want to record, or create a new one. More information in How to configure application access policies for EPM Windows.
- In the Applications tab, set Record session for these applications to Enabled.
- Click Save.
Info
An application that is not part of any access policy is not recorded. If an application is in more than one access policy and any of them has recording disabled, EPM Windows does not record it.
Verify your results
- Run one of the applications on a workstation with the EPM Windows agent.
- About 15 minutes after the execution ends, go to EPM > Reports > Recorded Executions.
- Find the execution and click Play to watch the recording.
If the execution does not appear, see EPM Windows sessions are not recorded.